HOBBYWING XRotor Pro H200A 14S FOC
Series: HOBBYWING ESCs for drone motors
Not the right version? The data comes from vehicle registers holding many near-identical versions side by side. Photograph the data plate — we read make and type from it. Open the scanner e-mail address required
The Hobbywing XRotor Pro H200A 14S FOC is a single-motor ESC from the Chinese manufacturer for heavy multicopters with field-oriented control (FOC). It drives one motor and weighs 270 g without leads.
Here the name fits one of the current ratings: the 200 A is the peak current for 3 s, the continuous current is 100 A. Sizing follows the 100 A. The voltage window runs from 6S to 14S, i.e. from 25.2 V to 58.8 V fully charged. Control is by PWM and CAN, and Dual Throttle means two throttle inputs. Telemetry runs over CAN; for evaluation the manufacturer names the accessory DataLinkBox G3. The protection rating is IP55, meaning protection against dust and water jets, and IP67 on request, which means dust-tight and resistant to temporary immersion.
Frame and law: an aircraft with these controllers is classified as a whole; from 25 kg take-off mass the specific category begins. The battery decides the transport: on 14S each ampere-hour is worth about 52 Wh, on 6S only 22.2 Wh, and the IATA limits of 100 and 160 Wh therefore lie at different capacities.
For selection and wear the data side pays off: current and temperature histories from the CAN telemetry show creeping overload before a component fails. At 100 A continuous, power connectors, lead cross-section and heat removal are critical; check the IP seal after use in rain or dust.
Technical data
Other data
| Cell count (S) | 6-14Scorrect |
|---|---|
| Charging channels | 1correct |
| Continuous current (A) | 100 Acorrect |
| Integrated propulsion unit | nocorrect |
| Peak current (A) | 200 Acorrect |
| Protocol | PWM, CAN (dual throttle)correct |
| Supported firmware | FOC proprietaercorrect |
| Telemetry | yescorrect |
| Weight (g) | 270correct |
What to check before buying
- Check the hour meter against the service records — a replaced instrument is the most common gap.
- Compare the data plate and chassis number with the papers.
- Ask about parts availability for this build year — the running costs hang on it.
A general list for this type of machine — no substitute for an inspection or an appraiser.
We do not sell machines. We ask the dealers who carry this model and come back with price and lead time.
Request a quote →
We ask the suppliers and come back with price and lead time.
Request spare parts →
This page carries 9 individual figures for this model. What we cannot document is not here — we leave gaps open rather than estimate them.
Missing a figure you were looking for? Report it →
Know this machine better? Have a photo, a manual, or know that a figure is wrong? Add it to the register →
