T-MOTOR THUNDER 200A 24S
Series: T-MOTOR ESCs for drone motors
Not the right version? The data comes from vehicle registers holding many near-identical versions side by side. Photograph the data plate — we read make and type from it. Open the scanner e-mail address required
The T-MOTOR THUNDER 200A 24S is a powerful single-motor ESC from the Chinese maker T-MOTOR for heavy multicopters on 12S to 24S. It drives one motor, reports data back through a UART-TTL interface and has protection rating IP54.
The 200 A figure does not separate continuous from peak current. Anyone sizing the controller therefore sets the motor's continuous current clearly below it and allows reserve for heat. The voltage window runs from 12S to 24S, i.e. up to 100.8 V fully charged with lithium-polymer cells at 4.2 V. UART-TTL is a serial interface at logic level through which operating data is read out; telemetry is thus available. IP54 means protection against dust and splashing water, not against water jets or immersion.
Frame and law: on 24S each ampere-hour of battery is about 89 Wh, and from about 1.8 Ah a pack is above the IATA limit of 160 Wh and travels only as dangerous goods. Above 100 V DC, handling the battery needs special care, for example low-spark connectors and pre-charging. Aircraft of this drive class are often above 25 kg take-off mass and belong in the specific category with an operational authorisation.
For selection, cooling counts: housing and airflow determine how much current is possible continuously. Wear shows at power connections, seals and capacitors; check after heat, rain or a crash. The operating data read out helps to recognise overload early.
Technical data
Other data
| Cell count (S) | 12-24Scorrect |
|---|---|
| Charging channels | 1correct |
| Continuous current (A) | 200 Acorrect |
| Integrated propulsion unit | nocorrect |
| Protocol | UART-TTL (Datenrueckmeldung)correct |
| Telemetry | yescorrect |
What to check before buying
- Check the hour meter against the service records — a replaced instrument is the most common gap.
- Compare the data plate and chassis number with the papers.
- Ask about parts availability for this build year — the running costs hang on it.
A general list for this type of machine — no substitute for an inspection or an appraiser.
We do not sell machines. We ask the dealers who carry this model and come back with price and lead time.
Request a quote →
We ask the suppliers and come back with price and lead time.
Request spare parts →
This page carries 6 individual figures for this model. What we cannot document is not here — we leave gaps open rather than estimate them.
Missing a figure you were looking for? Report it →
Know this machine better? Have a photo, a manual, or know that a figure is wrong? Add it to the register →
