Gremsy Mio Two-Axis
Series: Gremsy Gimbals for drone cameras
Not the right version? The data comes from vehicle registers holding many near-identical versions side by side. Photograph the data plate — we read make and type from it. Open the scanner e-mail address required
The Gremsy Mio Two-Axis is the two-axis version of the Mio gimbal, built by the Vietnamese maker Gremsy for mid-sized multicopters. It is meant for front-mounted cameras weighing up to 400 g.
Tilt (±130°) and roll (±60°) are stabilised. There is no yaw axis, the viewing direction follows the aircraft; that suffices for simple tasks but shows rotations of the aircraft in the picture. The gimbal weighs 180 g, and the maximum payload is 400 g for camera and lens together. It connects through USB 2.0 (Type C), UART, S-Bus or PPM; a Micro HDMI port is also present.
Gimbal and largest permitted camera add up to 580 g and so stay below the 900 g limit of EU class C1; the total take-off mass of the aircraft remains decisive (C0 applies below 250 g). Images of people and property fall under data-protection law, and with a camera that can show people, the operator must be registered.
Choosing a two-axis model saves weight and power but gives up compensation of yaw movements; for a pan in the picture, the aircraft itself must turn. The camera's centre of gravity must be right on the tilt and roll axes, otherwise the motors heat up. Check play in the axes, the dampers, the connectors and the cable routing at the pivot points.
Technical data
Other data
| Gimbal axes | 2correct |
|---|---|
| Interface and mounting | USB 2.0 (Typ C), UART, SBUS, PPM, Micro HDMIcorrect |
| Maximum payload (g) | 400correct |
| Weight (g) | 180correct |
What to check before buying
- Check the hour meter against the service records — a replaced instrument is the most common gap.
- Compare the data plate and chassis number with the papers.
- Ask about parts availability for this build year — the running costs hang on it.
A general list for this type of machine — no substitute for an inspection or an appraiser.
We do not sell machines. We ask the dealers who carry this model and come back with price and lead time.
Request a quote →
We ask the suppliers and come back with price and lead time.
Request spare parts →
This page carries 4 individual figures for this model. What we cannot document is not here — we leave gaps open rather than estimate them.
Missing a figure you were looking for? Report it →
Know this machine better? Have a photo, a manual, or know that a figure is wrong? Add it to the register →
