Cela Other models
2 models in this series
Cela DT-25 I – other models: the collective page of the register entry with a uniform four-cylinder engine of 2.3 litres, gross weight 3,500 kg, body length 7.39 m
This page gathers the versions listed in the register under the designation Cela DT-25 I, which the register could not assign to a named series of its own. Both vehicles listed carry the same type name DT-25 I and share matching values, so this collective page focuses on a single, clearly defined body type.
Read on 3 more paragraphs
The register lists 2 versions here with a uniform displacement of 2,287 cm³ from four-cylinder engines, a kerb weight of 3,245 kg, a gross vehicle weight of 3,500 kg, a length of 7,390 mm and a width of 2,100 mm.
With a body length of just under 7.4 m and a gross weight of 3,500 kg, the DT-25 I ranks among the large-volume bodies within the category B driving licence, used in distribution and courier transport for bulky but light loads; the matching values of both versions point to a standardised build of this particular body type.
For a used example, check the condition and tightness of the body over its full length, the condition of the clutch, brakes and suspension given the high kerb weight relative to the gross weight, and corrosion on the chassis and frame extensions; with such a long body, also check the frame for flex and twist and the condition of the rear tie-down points and roof seams. Drivetrain parts run through the dealer network of the respective base vehicle.
Sources: SpecCodex register, model data: Cela DT-25 I (weitere Modelle)
Models
Van in 3D section
Turn the model, look inside and click an assembly — each one is explained.
