Opale Aero System SARL (Opale Paramodels / Opale Parachutes) Parachute de secours Crossfly 7 m2 (OP17114)
Series: Opale Aero System SARL (Opale Paramodels / Opale Parachutes) Parachute recovery systems for drones
Not the right version? The data comes from vehicle registers holding many near-identical versions side by side. Photograph the data plate — we read make and type from it. Open the scanner e-mail address required
The Crossfly 7 m² (OP17114) from Opale Aero System (France) is a rescue parachute with a cross canopy for drones of 4 to 9 kg total weight. Only the parachute is supplied, in a container of 17 x 17 cm; ejection and release come from a separate system.
The manufacturer's table runs from 3.1 m/s and 33 J at 7 kg to 4.2 m/s and 114 J at 13 kg; at 9 kg, the upper end of the range of use, the sink rate is 3.5 m/s. The parachute weighs 308 g. The figures show how strongly energy grows with mass: 114 J at 13 kg against 33 J at 7 kg, although the sink rate rises only from 3.1 to 4.2 m/s.
The Crossfly brings neither ejection nor release and therefore no minimum deployment altitude of its own; that follows from the interplay with the chosen ejection system. For flights over people or in certain scenarios of the Specific category, evidence to ASTM F3322 or EASA MoC Light-UAS.2511 and 2512 may be required; it applies to the complete combination of parachute, ejection and aircraft, not to the parachute alone. The 308 g count towards take-off weight.
With a parachute alone, care is about the fabric: after use, check canopy and lines for tears, chafing, dirt and moisture, store them protected from UV light and wet, and repack as the manufacturer specifies. The container of 17 x 17 cm has to fit the ejection system. Selection follows mass: above 9 kg the aircraft leaves the intended range, although the table runs to 13 kg.
Technical data
Other data
| Compatible with | Drohnen 4-9 kgcorrect |
|---|---|
| Descent rate (m/s) | 3.5correct |
| Maximum take-off mass (kg) | 9correct |
| Weight (g) | 308correct |
What to check before buying
- Check the hour meter against the service records — a replaced instrument is the most common gap.
- Compare the data plate and chassis number with the papers.
- Ask about parts availability for this build year — the running costs hang on it.
A general list for this type of machine — no substitute for an inspection or an appraiser.
We do not sell machines. We ask the dealers who carry this model and come back with price and lead time.
Request a quote →
We ask the suppliers and come back with price and lead time.
Request spare parts →
This page carries 4 individual figures for this model. What we cannot document is not here — we leave gaps open rather than estimate them.
Missing a figure you were looking for? Report it →
Know this machine better? Have a photo, a manual, or know that a figure is wrong? Add it to the register →