AGCO Massey Ferguson MF 7618
Built: 2012–2015 · Series: MF 7600
More machines from model year 2012
Not the right version? The data comes from vehicle registers holding many near-identical versions side by side. Photograph the data plate — we read make and type from it. Open the scanner e-mail address required
Massey Ferguson MF 7600 (2012–2015) – the six-cylinder upper class from Beauvais: MF 7615 to MF 7626, the last digits as power step, AGCO Power six-cylinder of 6.6 litres with SCR, Dyna-6 and Dyna-VT, 103 to 147 kW
The MF 7600 was the range with which Massey Ferguson merged the MF 6400 and MF 7400 in the class from 140 to 280 hp in 2012 – six-cylinders from Beauvais with the choice between Dyna-6 semi-powershift and stepless Dyna-VT, in the equipment lines Essential, Efficient and Exclusive. The type logic: 76 marks the range, the last two digits the power step – MF 7615 about 150 hp, MF 7618 about 175, MF 7619 about 185, MF 7622 about 215 hp, up to the MF 7626 with about 260 hp – each with power boost for PTO and transport work. The engine in the models recorded here is the AGCO Power six-cylinder of 6.6 litres from Linnavuori at 2,200 rpm, with common-rail injection and SCR exhaust aftertreatment to stage IIIB; the big models from the MF 7624 upward carry the 7.4 litre engine.
Read on 3 more paragraphs
The register lists 5 versions with 103 to 147 kW from the six-cylinder of 6,600 cm³, torque from 660 to 740 Nm, PTO outputs from 135 to 165 hp, lift capacities from 7,100 to 8,100 kg, unladen weights from 6,650 to 7,920 kg, a length of 5,085 mm and heights from 3,110 to 3,190 mm.
The MF 7600 was the tractor of contractors and arable farms that took on the John Deere 6R, Fendt 700 Vario and Claas Arion 600; in 2015 the MF 7700 with emission stage IV followed in the same logic.
On used tractors, operating hours, engine and SCR system, Dyna-6 or Dyna-VT transmission (clutches, oil history, calibration), front-axle and cab suspension, hydraulics and electronics, tyres count; parts run through the AGCO network.
Sources: SpecCodex register, model data: Massey Ferguson MF 7600, Massey Ferguson (AGCO, Hersteller, Beauvais)
Technical data
Engine
| Fuel | dieselcorrect |
|---|---|
| Power | 165 hp (121 kW)correct |
| Rated speed | 2,200 rpmcorrect |
| Torque | 740 Nmcorrect |
| Cylinders | 6correct |
| Displacement | 6,600 cm³correct |
| Cooling | water-cooledcorrect |
Dimensions and weights
| Wheelbase | 2,870 mmcorrect |
|---|---|
| Unladen weight | 6,850 kgcorrect |
Drivetrain and chassis
| Drive | four-wheel drivecorrect |
|---|---|
| Gearbox | Ausstattungsabhängigcorrect |
| Front tyres | 480 / 70 R 28correct |
| Rear tyres | 580 / 70 R 38correct |
| Top speed | 40 km/hcorrect |
Working data
| Lifting capacity | 8,100 kgcorrect |
|---|---|
| Fuel tank capacity | 335 lcorrect |
Other data
| Linkage category | Cat IIIcorrect |
|---|---|
| PTO output | 165 hpcorrect |
| PTO speed | 540/540E/1000/1000Ecorrect |
Where this model stands
Power-to-weight ratio: 17.7 kW/t (121 kW / 6.8 t)
Power class: Large (100–180 hp)
Stronger than 87% of the tractors in the register — out of 15,663 models with a stated power figure.
Calculated from the documented figures above — not a rating.
Frequently asked questions
How much power does the AGCO Massey Ferguson MF 7618 have?
The AGCO Massey Ferguson MF 7618 delivers 165 hp.
How much does the AGCO Massey Ferguson MF 7618 weigh?
The unladen weight is 6,850 kg.
What engine does the AGCO Massey Ferguson MF 7618 have?
6 cylinders, 6,600 cm³ displacement, Diesel.
How fast does the AGCO Massey Ferguson MF 7618 go?
Top speed is 40 km/h.
What is the PTO output of the AGCO Massey Ferguson MF 7618?
PTO output is 165 hp. PTO speeds: 540/540E/1000/1000E rpm.
How much does the rear linkage of the AGCO Massey Ferguson MF 7618 lift?
The rear linkage lifts 8,100 kg.
When was the AGCO Massey Ferguson MF 7618 built?
Production years: 2012–2015.
What to check before buying
- Check the hour meter against the service records — a replaced instrument is the most common gap.
- Compare the data plate and chassis number with the papers.
- Check the weights in the papers against the figures here — attachments change them.
- Check front and rear tyre sizes: mismatched pairs strain the drivetrain.
- Shift the gearbox cold and warm — jumps only show up at temperature.
- Load the hydraulics and watch for sag.
- Ask about parts availability for this build year — the running costs hang on it.
A general list for this type of machine — no substitute for an inspection or an appraiser.
We do not sell machines. We ask the dealers who carry this model and come back with price and lead time.
Request a quote →
We ask the suppliers and come back with price and lead time.
Request spare parts →
This page carries 20 individual figures for this model. They come from 1 recorded source; every figure can be traced there. What we cannot document is not here — we leave gaps open rather than estimate them.
Missing a figure you were looking for? Report it →
Know this machine better? Have a photo, a manual, or know that a figure is wrong? Add it to the register →
Other models in this series
Sources: Wikibooks Traktorenlexikon (CC BY-SA 4.0) (retrieved August 2026) · How we check the data
Tractor in 3D section
Turn the model, look inside and click an assembly — each one is explained.
