Technical register for agricultural, construction and commercial machinery · sourced data
Start › Electric motors › General Electric › Other models › 5KFS162XAA2007

General Electric 5KFS162XAA2007

Series: Other models

The photo shows the 5KFS162XAA2004 from the same series. Source: prom63.ru

Not the right version? The data comes from vehicle registers holding many near-identical versions side by side. Photograph the data plate — we read make and type from it. Open the scanner e-mail address required

The 5KFS162XAA2007 from General Electric is a three-phase induction motor. The rated output is 11 kW. The motor is four-pole, which at 50 Hz gives a synchronous speed of 1,500 rpm. The housing is frame size 160 M in foot-mounted form. The protection class is IP55. The efficiency is 92.7 per cent at full load, 93.4 per cent at 75 per cent load and 93.3 per cent at half load. The motor weighs 143 kg. The mounting arrangement to IEC 60034-7 is B3. The motor is built in Mexico. The figures come from the Australian MEPS register under the GEMS Determination 2012; measured to IEEE 112-B(USA). Rated output across the General Electric range ranges from 0.75 to 90 kW; the 5KFS162XAA2007 sits at the bottom of that range with 11 kW. Its immediate neighbours are the 5K132SBIM2013 below it with 5.5 kW and the 5K160LBIM2013 above it with 15 kW. 25 General Electric models across 3 series are on record.

General Electric – other models: the collective page of MEPS-registered 5K-range three-phase motors outside the named versions, frame sizes 80 to 280, 0.75 to 90 kW, manufactured in China and Mexico

This page gathers the General Electric three-phase motors the Australian energy-efficiency register could not assign to its own range. General Electric, founded in 1892 in the USA, is one of the world's oldest electrical engineering groups and built one of the best-known North American standard-motor ranges with the 5K series. The designations recorded in the register, such as 5K100LBIM2013 or 5K280MBIM2013, start with the 5K range code, followed by the IEC frame size (80 to 280) and a letter for the build form (S, M or L); the register also lists the separate designation 5KFS162XAA for four further versions.

Read on 3 more paragraphs

The register lists here 15 versions with 0.75 to 90 kW rated output, two- to four-pole, at a supply voltage of 415 V or optionally 380/400/415 V. Full-load efficiencies range from 73.4 to 94%, and at 75% load from 73.7 to 94%. Protection is uniformly IP55, frame sizes run from 80 to 280; China (11) and Mexico (4) are recorded as manufacturing countries. Testing mostly followed the older AS/NZS 1359.5:2000 standard (10), alongside the 2012 GEMS determination (4) and AS/NZS 1359.5:2004 (1); four of the 15 motors reach the 2005 High Efficiency Level, the remaining eleven stay unclassified. The mounting form is mostly B3 (12 versions).

With this range, General Electric serves the North American and Australia-Pacific markets for classic industrial standard motors, competing with Baldor, Marathon and Asian suppliers; the mix of older models registered under the Legacy standard and newer 2012 GEMS versions shows a range built up over many years.

When buying used, on the older motors tested under the Legacy standard, winding condition and a checked insulation resistance matter especially; on all versions, bearing, shaft and key condition and visible corrosion on the terminal box and fan cover matter; a legible nameplate with frame size, pole count and, where present, the efficiency-level mark helps with assessment. Spares run through the GE distribution network.

Sources: SpecCodex register, model data: General Electric (weitere Modelle, MEPS-Registrierungen), General Electric (manufacturer)

Technical data

Engine

Rated output11 kWcorrect

Dimensions and weights

Weight143 kgcorrect

Electrical data

Rated voltage380/400/415 Vcorrect
Number of poles4correct
Protection classIP55correct
Frame size160 M (foot)correct
Mounting (IEC 60034-7)B3correct
Efficiency at full load92.7 %correct
Efficiency at 75 % load93.4 %correct
Efficiency at half load93.3 %correct

Origin and approval

Country of manufactureMexicocorrect

Other data

Standard appliedGreenhouse and Energy Minimum Standards (Three Phase Electric Motors) Determination 2012correct
Test methodIEEE 112-B(USA)correct

Frequently asked questions

How much power does the General Electric 5KFS162XAA2007 have?

The General Electric 5KFS162XAA2007 delivers 11 kW.

What to check before buying

  • Match the data plate against the order: frame size, mounting and rating have to agree.
  • Check the ingress rating against the installation site — outdoors or in dust the demands differ.
  • Hold the mounting form and dimensions against the existing seat before ordering.
  • The pole count sets the speed — when replacing an older unit, compare this first.
  • For used units, ask about winding condition and bearing play.
  • Ask about parts availability for this series — the running costs hang on it.

A general list for this type of machine — no substitute for an inspection or an appraiser.

Looking for this machine?
We do not sell machines. We ask the dealers who carry this model and come back with price and lead time.
Request a quote →
Need parts for this model?
We ask the suppliers and come back with price and lead time.
Request spare parts →

This page carries 24 individual figures for this model. They come from 1 recorded source; every figure can be traced there. What we cannot document is not here — we leave gaps open rather than estimate them.

Missing a figure you were looking for? Report it →

Know this machine better? Have a photo, a manual, or know that a figure is wrong? Add it to the register →

Other models in this series

Sources: Energy Rating — Australian government equipment register (retrieved August 2026) · How we check the data

Electric motor in 3D section

Turn the model, look inside and click an assembly — each one is explained.

Compare