Technical register for agricultural, construction and commercial machinery · sourced data
Start › Electric motors › Electramo › Other models › YE3-160M-4

Electramo YE3-160M-4

Series: Other models

Not the right version? The data comes from vehicle registers holding many near-identical versions side by side. Photograph the data plate — we read make and type from it. Open the scanner e-mail address required

The Electramo YE3-160M-4 is a three-phase induction motor built by Electramo. The rated output is 11 kW. The motor is four-pole, which at 50 Hz gives a synchronous speed of 1,500 rpm. The rated voltage is 400 V. The protection class is IP55. The efficiency is 91.4 per cent at full load, 91.4 per cent at 75 per cent load and 89.7 per cent at half load. The mounting arrangement to IEC 60034-7 is V1. The motor is built in Belgium. The data is based on the Australian MEPS registration under the GEMS Determination 2019; measured to IEEE 112: 2017. Rated output within this group ranges from 0.18 to 1,119 kW; the YE3-160M-4 sits at the bottom of that range with 11 kW. Its immediate neighbours are the 1D132M2-4 below it with 10 kW and the 07K349Y251M1 above it with 11.2 kW.

Electramo – other models: the collective page of MEPS-registered YE3 three-phase motors from Belgium outside the named ranges, frame size 160, 11 kW, 2018 High Efficiency Level

This page gathers the Electramo three-phase motors the Australian energy-efficiency register could not assign to a named range. The designations recorded in the register, YE3-160M-4 and YE3-160M1-2, follow the YE3 scheme developed in China and adopted internationally, corresponding to the IE3 level under IEC 60034-30-1; frame size 160 stays the same for both motors, which differ in build length (M, M1), pole count (4, 2) and mounting form – one a foot type, one a B5 flange type in the vertical V1 position.

Read on 3 more paragraphs

The register lists here 2 versions, each with 11 kW rated output, two- or four-pole, for a 400 V supply, with full-load efficiencies from 91.22 to 91.4% and at 75% load from 91.39 to 91.76%. Protection is IP55, the mounting code V1. Both motors reach the 2018 High Efficiency Level, which under the 2019 GEMS determination corresponds roughly to the IE3 class. Manufacturing takes place in Belgium.

The change from two to four poles at the same frame size 160 chiefly changes the synchronous speed: 3,000 rpm on two poles versus 1,500 rpm on four poles at 50 Hz, while the rated output of 11 kW stays the same for both versions; such motors with confirmed IE3 efficiency are a standard drive for pumps and fans in applications where energy efficiency is mandated.

When buying used, bearing condition and a checked insulation resistance of the winding, the condition of shaft, key and fan cover, a legible nameplate with frame size, pole count and efficiency class, and on the B5 flange version also the condition of the centring spigot matter. Spares run through Electramo's Belgian distribution.

Sources: SpecCodex register, model data: Electramo (weitere Modelle, MEPS-Registrierungen)

Technical data

Engine

Rated output11 kWcorrect

Electrical data

Rated voltage400 Vcorrect
Number of poles4correct
Protection classIP55correct
Frame size160M V1 (B5 flange)correct
Mounting (IEC 60034-7)V1correct
Efficiency at full load91.4 %correct
Efficiency at 75 % load91.39 %correct
Efficiency at half load89.73 %correct

Origin and approval

Country of manufactureBelgiumcorrect

Other data

Standard appliedGreenhouse and Energy Minimum Standards (Three Phase Electric Motors) Determination 2019correct
Test methodIEEE 112: 2017correct

Frequently asked questions

How much power does the Electramo YE3-160M-4 have?

The Electramo YE3-160M-4 delivers 11 kW.

What to check before buying

  • Match the data plate against the order: frame size, mounting and rating have to agree.
  • Check the ingress rating against the installation site — outdoors or in dust the demands differ.
  • Hold the mounting form and dimensions against the existing seat before ordering.
  • The pole count sets the speed — when replacing an older unit, compare this first.
  • For used units, ask about winding condition and bearing play.
  • Ask about parts availability for this series — the running costs hang on it.

A general list for this type of machine — no substitute for an inspection or an appraiser.

Looking for this machine?
We do not sell machines. We ask the dealers who carry this model and come back with price and lead time.
Request a quote →
Need parts for this model?
We ask the suppliers and come back with price and lead time.
Request spare parts →

This page carries 21 individual figures for this model. They come from 1 recorded source; every figure can be traced there. What we cannot document is not here — we leave gaps open rather than estimate them.

Missing a figure you were looking for? Report it →

Know this machine better? Have a photo, a manual, or know that a figure is wrong? Add it to the register →

Other models in this series

Sources: Energy Rating — Australian government equipment register (retrieved August 2026) · How we check the data

Electric motor in 3D section

Turn the model, look inside and click an assembly — each one is explained.

Compare